PnP - Refactored the PnP implementation to handle the DigiRig Mobile no CAT control use case. Currently, the best workaround for the moment is to restore the JS8Call INI configuration on every startup using a template file. This will wipe out user settings on every start-up, but it is stable for now. I have a couple of long term solutions to preserve the user's settings.

overlay/opt/emcomm-tools/bin/et-js8call

@@ -6,10 +6,12 @@
 # Purpose : Wrapper script for starting JS8Call with PnP support
 #
 # Preconditions
-# 1. Support radio and audio interface are connected and properly detected
+# 1. Supported radio and audio interface are connected and properly detected
 #
 # Postconditions
-# 1. JS8Call is started with audio settings updated
+# 1. JS8Call audio settings updated
+# 2. JS8Call rig settings updated
+# 3. JS8Call started
 
 usage() {
   echo "usage: $(basename $0) <command>"
@@ -36,6 +38,20 @@ start() {
 update-config () {
 
     JS8CALL_CONF_FILE="${HOME}/.config/JS8Call.ini"
+    JS8CALL_TEMPLATE_CONF_FILE=${ET_HOME}/conf/template.d/js8call/JS8Call.rigctl.ini
+
+    # Special case for the DigiRig Mobile when connected to a radio that does 
+    # not support CAT control.
+    if [ -L "${ET_HOME}/conf/radios.d/active-radio.json" ]; then
+      RIG_ID=$(cat "${ET_HOME}/conf/radios.d/active-radio.json" | jq -r .rigctrl.id)
+
+      if [ "${RIG_ID}" = "6" ]; then
+        JS8CALL_TEMPLATE_CONF_FILE=${ET_HOME}/conf/template.d/js8call/JS8Call.no-rigctl.ini
+      fi
+    fi
+
+    cp ${JS8CALL_TEMPLATE_CONF_FILE}  ${JS8CALL_CONF_FILE}
+    et-log "Replaced JS8Call configuration with template: ${JS8CALL_TEMPLATE_CONF_FILE}"
 
     # 1. Check if the symlink was created by the udev rules
     if [ -e /dev/et-audio ]; then
@@ -75,6 +91,7 @@ update-config () {
       notify_user "Can't start JS8Call. No supported audio device plugged in."
       exit 1
     fi
+
 }
 
 case $1 in