PnP - Updated et-system-info to have a better human label with a non CAT device is used; added notes to the DigiRig Mobile (no CAT) radio definition and set the Hamlib ID to 6 for future purposes; updated comments in wrapper-rigctld

overlay/opt/emcomm-tools/bin/et-system-info

@@ -101,7 +101,7 @@ case $1 in
           echo "Connected. Can't access VFO"; 
         fi
       else
-        echo "Connected. rigctld not running"
+        echo "Connected. No rig control"
       fi
     else
       echo "Not connected"; 

overlay/opt/emcomm-tools/conf/radios.d/digirig-mobile-no-cat.json

@@ -3,10 +3,12 @@
   "vendor": "DigiRig",
   "model": "Mobile (No CAT)",
   "rigctrl": {
-    "id": "1",
+    "id": "6",
     "ptt": "RTS"
   },
   "notes": [
-    "Uses RTS to trigger PTT"
+    "Set your VFO manually",
+    "Adjust your volume, RF gain and squelch manually",
+    "This mode uses the RTS signal to trigger the PTT"
   ]
 }

overlay/opt/emcomm-tools/sbin/wrapper-rigctld.sh

@@ -34,8 +34,8 @@ start() {
   if [ -L "${ET_HOME}/conf/radios.d/active-radio.json" ]; then
     RIG_ID=$(cat "${ET_HOME}/conf/radios.d/active-radio.json" | jq -r .rigctrl.id)
 
-    # All devices that have no CAT control must have their ID set to 1. This
-    # a special test mode provided by Hamlib's rigctl NET interface.
+    # All VOX devices use the dummy mode provided by Hamlib. This helps maintain 
+    # a cleaner interface by leveraging rigctl NET in applications.
     if [ "${RIG_ID}" = "1" ]; then
       et-log "Starting dummy rigctld service for device with no CAT support."